UTV FRONT RACK
MODEL UVFR751

With its handsome but rugged design, the Front Rack actually transforms a wimpy-looking UTV into a machine with an attitude and ability.

The Front Rack mounts quickly and easily onto most full-sized UTV’s and features a unique pivoting mechanism for gaining access to the front storage compartment. By removing two quick-clip pins, in just seconds the Front Rack can be rotated forward — allowing the storage compartment door to be opened and closed.

The Front Rack is constructed of aircraft aluminum and provides an 18″ x 50″ x 7″ carrying cradle with multiple tie-down points. A super-tough, sleek, powder-coat finish on the Front Rack gives it good looks and insures lasting quality. The Front Rack weighs only 14 lbs, has a load limit of 250 lbs and ships by UPS.

!! WILL NOT fit a Polaris Ranger 570 Midsized UTV with a Pro-Fit Style Roll Cage!!

!! WILL NOT fit a Honda Pioneer 500!!

!! WILL NOT fit a 2020-2022 Polaris Ranger 1000 Reg or Crew Cab!!

UTV must have a tubular bumper/brush guard for the Front Rack to mount to. 

FOR INSTALLATION OF THE UTV FRONT RACK ON FULL SIZED UTV’S WITH A PRO-FIT ROLL CAGE:  

  1.  INSTALL 1- 5/16” X 1 ¼” BOLT, 2 FLAT WASHERS AND LOCKNUT INTO MIDDLE HOLE OF THE LEFT AND RIGHT ANGLE BRACKETS (BRACKETS WITH THREE HOLES ON ONE SIDE).  TIGHTEN COMPLETELY.  NOTE: THIS BOLT WILL ACT AS A HORIZONTAL REST WHEN INSTALLED. 
  2. REMOVE THE BOTTOM ALLEN BOLT SECURING ROLL BAR SECTIONS ON EACH SIDE OF POLARIS
  3. INSTALL THE BRACKET TO EACH SIDE OF RANGER USING 1- 5/16” X 3 ½” BOLT AND 12 FLAT WASHERS AND LOCKNUT.
  4. 10 OF THE FLAT WASHERS ARE TO BE USED BETWEEN ANGLE BRACKET AND ROLL BAR.  THESE WILL FILL THE VOID LEFT BY THE HEAD OF THE REMOVED ALLEN BOLT.
  5. BOLT WILL PROTRUDE THROUGH INSIDE OF ROLL BAR.  TIGHTEN ALL ASSEMBLIES.  BRACKETS SHOULD SIT HORIZONTAL TO THE GROUND.

MADE WITH PRIDE IN THE USA!